element with lumped parameters

element with lumped parameters
element with lumped parameters RT Glied n mit konzentrierten Parametern

English-German dictionary of Electrical Engineering and Electronics. 2013.

Игры ⚽ Поможем сделать НИР

Schlagen Sie auch in anderen Wörterbüchern nach:

  • Scattering parameters — or S parameters are properties used in electrical engineering, electronics engineering, and communication systems engineering describing the electrical behavior of linear electrical networks when undergoing various steady state stimuli by small… …   Wikipedia

  • Metamaterial antenna — This Z antenna tested at the National Institute of Standards and Technology is smaller than a standard antenna with comparable properties. Its high efficiency is derived from the Z element inside the square that acts as a metamaterial, greatly… …   Wikipedia

  • Photonic metamaterial — Electromagnetism Electricity · …   Wikipedia

  • Mechanical filter — Figure 1. A mechanical filter made by the Kokusai Electric Company intended for selecting the narrow 2 kHz bandwidth signals in SSB radio receivers. It operates at 455 kHz, a common IF for these receivers, and is dimensioned 45×15×15 mm ( …   Wikipedia

  • Loading coil — In electronics, a loading coil or load coil is a coil (inductor) that does not provide coupling to any other circuit, but is inserted in a circuit to increase its inductance. The need was discovered by Oliver Heaviside in studying the… …   Wikipedia

  • Image impedance — is a concept used in electronic network design and analysis and most especially in filter design. The term image impedance applies to the impedance seen looking in to the ports of a network. Usually a two port network is implied but the concept… …   Wikipedia

  • Modal analysis — is the study of the dynamic properties of structures under vibrational excitation. Modal analysis is the field of measuring and analysing the dynamic response of structures and or fluids when excited by an input. Examples would include measuring… …   Wikipedia

  • Smith chart — The Smith Chart, invented by Phillip H. Smith (1905 1987), [Smith, P. H.; Transmission Line Calculator; Electronics, Vol. 12, No. 1, pp 29 31, January 1939] [Smith, P. H.; An Improved Transmission Line Calculator; Electronics, Vol. 17, No. 1, p… …   Wikipedia

  • Metal-mesh optical filters — are optical filters made from stacks of metal meshes and dielectric. They are used as part of an optical path to filter the incoming light to allow frequencies of interest to pass while reflecting other frequencies of light. Metal mesh filters… …   Wikipedia

  • Electrical network — For electrical power transmission grids and distribution networks, see Grid (electricity). A simple electric circuit made up of a voltage source and a resistor. Here, V = iR, according to Ohm s Law. An electrical network is an interconnection of… …   Wikipedia

  • Power dividers and directional couplers — A 10 dB 1.7–2.2 GHz directional coupler. From left to right: input, coupled, isolated (terminated with a load), and transmitted port …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”